產品目錄
Products
產品中心
YUKEN變量柱塞泵，油研泵技術數據
YUKEN變量柱塞泵，油研泵技術數據的高度pump generates excessive Whenever there is fear of excessive load, please use rubber 7. Suction Piping In case the pump is installed above the oil level
YUKEN變量柱塞泵，油研泵技術數據
suction piping and suction line filter should be located
lower than the pump position to prevent air in the suction
Install drain piping according to the chart and ensure that
3001) is recommended for this purpose
泵入口允許的吸入壓力為
-16+50 kPa（真空5 in.Hg，7 PSIG）。
對于吸入口的管道，請使用相同的管道
直徑與要使用的管道法蘭的直徑相同。
確保泵吸入口的高度pump generates excessive
Whenever there is fear of excessive load, please use rubber
7. Suction Piping
In case the pump is installed above the oil level, thecan otherwise lead
to breakdowns and shorten the life of the unit. Please
maintain the degree of contamination within NAS Grade
The suction port must be equipped with at least a 100 mm
(150 mesh) reservoir type filter and the return line must
have a line filter of under 10 mm.
YUKEN變量柱塞泵，油研泵技術數據
3. Mounting吸入壓力excessive load from the piping to the oil.
In case AR16 and AR22 pump, a 距水庫的油位不到米（3.3英尺）。
When installing the pump the filling
在AR16和AR22泵的情況下，配合的螺旋扭矩
為4050Nm（354443 IN.1bs。）。 不要
- EBG-03-H-61TYUKEN液壓控制閥的特征
- S-BSG-03-2B3B-A240-N1-51原裝油研YUKEN2通電磁閥結構方式
- DSG-01-3C2-A240-N1-50安裝與使用油研YUKEN電磁閥
- DSG-01-3C4-D24-N1-51TYUKEN油研電磁閥詳解
- DSG-01-3C2-D24-GB4-30油研YUKEN電磁換向閥現貨多
- DSG-03-3C3-D24-N1-51TYUKEN油研電磁閥產品示意圖
- DSG-01-2B2-D24-N1-50油研YUKEN電磁閥部件一覽
- DSG-01-2D2-A100-51原裝油研YUKEN電磁閥結構材質
- EDFHG-04-140-3C40-XY日本YUKEN油研比例調速閥
- DSG-01-3C4-D24-N1-51T油研YUKEN電磁換向閥使用詳情
銷售部